HiTauing Aquarium LED Light for Fish Tank Light Programmable Auto On & Off w/Timer, for 18-57 Inch Freshwater Tank Planted Aquarium Light, Full Spectrum Dimmable 7 Colors 10 Intensity w/LCD Controller
(as of Jan 24,2023 02:22:32 UTC – Details)
1.The fish tank light has IP68 waterproof, but the adapter is not waterproof, please do not put the adapter and the wire into the water.
2.The light board may become hot after long time use. This is a normal phenomenon, please avoid touching the light board directly with your hands. Turn off the power and wait for 10-15 minutes before touching it.
3.The operation of the aquarium light is a bit complicated, you may encounter difficulties during use, please read the manual carefully to set up, if you still encounter problems, we can solve the problem for you as soon as possible.
HiTauing 2021 Upgraded LED Aquarium Light
24 HOUR AUTO CYCLE
In default auto cycle, you can use daylight and moonlight option to create your own custom 24 hours light cycle, altering auto on /off time, adjusting light color and intensity for moonlight option. Preset lighting auto turns on at 6:30 AM and auto turn off at 11:30 PM. The light can be set to turn on and off at the designated time which allows your fish get some rest at night.
COLOR GRADIENT LOOP
At the daylight and moonlight modes, it can be programmed into color gradient loop mode. In the daylight time period mode, the full-spectrum lighting is automatically turned on. In moonlight time period mode, color gradient cycle begins. The middle arrays of RGB LEDs slow turns from red into purple, blue, cyan, green, yellow to orange, continuous circulation of color gradient.
In ‘DIY mode’, you can use eight time slots to create your own custom 24-hour light cycle, adjusting ‘on/off’ and light intensity for each slot. DIY mode is full spectrum only. You cannot choose colors, you can only alter the brightness at certain time periods.
After finish the DIY mode setting, please remember to reset local time to activate DIY setting.
Daylight mode: automatically simulate sunrise, noon and sunset, the light color is full spectrum.
Moonlight mode: Automatically simulate the night, the light color is other 6 colored lights.
DIY mode: Customize 8 different time periods, and the brightness of each period can be adjusted.
2 modes available: the default auto cycle and the DIY cycle
Waterproof level: IP68 Water-Resistant Rating
Daylight and Moonlight Mode Cycle:
Full spectrum white light in the day and blue in the night.
1.Full spectrum period: 06:30-18:30, blue light period: 18:30-23:30.
2.Night colors can be changed, there are 6 kinds in total: dark blue, green, purple, cyan, yellow, red.
3.The brightness of the light changes in accordance with the curve designed.
4.You can change the full spectrum white light period start and end time; night start and night time.
5.NOTE: No matter when the set time starts, the brightness of the light will gradually become brighter.
8 Time Stages: L1, L2, L3, L4, L5, L6 —- All-optical; L7, L8 —- Blue light;10 Brightness: 10%, 20%, 30%, 40%, 50%, 60%, 70%, 80%, 90%, 100%;8 DIY setting time periods: Any time of the 24 hours.In each time stage can only set a brightness, and the start and end time of this time stage are set by yourself.After the L8 time period is over, the light will not turn off immediately, the fish tank light will turn off completely after 15 minutes. The brightness of the light for these 15 minutes is slowly dimmed until there is no.
Restore the Factory Settings:
The settings are wrong or the settings are confusing, you can restore the factory settings and start over. Long press the up and down keys at the same time for a few seconds, until “SOP” appears, then unplug the power, wait at least 3 seconds later, then plug again, it can restore the factory settings. After restoring factory settings, all the previous setting modes are cleared back to the default setting, and you can reset the desired mode.
10 Adjustable Brightness:
There are 10 kinds of brightness can be adjusted: 10%-100%, to simulate the effect of sunrise to sunset, and the brightness of the light can be set in different 8 Time Stages, which can realistically simulate natural light. Not only can it brighten the fish, it can also be applied to the growth of aquatic plants and promote photosynthesis.
Excellent High Efficient Heat Dissipation:
Fully encased 1.8 mm thickness aluminum shell where the heat sink was fixed onto helps to transfer the heat of the LED bulbs, so as to reduce light decay and extend its service life. The light housing is hot which indicates its excellent cooling performance. This system has adjustable mounting legs which can be used in aquariums widths of 12-18 inches, 18-24 inches, 24-30 inches, 30-36 inches, 36-42 inches, and 48-54 inches.
IP68 Waterproof Rating:
IP68 water resistant rating. Fully sealed and waterproof, high light transmittance, waterproof and easy to clean. No need to worry about splashes, or other accidental drops of water. Note that power connector is not waterproof, be careful not drops in water. Low voltage dc adapter makes our our light applicable for 100-240 volts, safe to use, low energy consumption, saving electric bill.
26-66 gal fish tank
60-120 gal fish tank
60-120 gal fish tank
20-50 gal fish tank
Fish tank heating
Fish tank heating
Fish tank heating
Fish tank cleaning
Fish tank heating
Product Dimensions:11.8 x 3.9 x 2.1 inches; 1.54 Pounds
Item model number:FG138-12-LED
Date First Available:March 14, 2021
【Default Mode- Programmable Daylight and Moonlight Cycle】Default full-spectrum daylight period 06:30-18:30, and blue moonlight 18:30-23:30. The 6 colors of moonlight and auto on/off – Day/Night start/ending time was programmable, the moonlight period could be set as single or 6 colors gradient loop. And the brightness curve under this model will follow the default setting to simulate real sunlight change, when simulate sunrise and sunset, it will take 15 minutes to slowly on/off.
【DIY Model- Programmable 8 Time Stages Customized Cycle】The brightness level and start & ending time of every time stage in L1-L8 were all programmable unlimited, but only 1 brightness level could be set during each stage. Full-spectrum daylight and 10 levels intensity dimmable available for L1-L6. Blue moonlight and 10 levels brightness adjustable available for L7-L8. Reset local time to activate DIY settings was necessary.
【Power-off Protection and Recovering Factory Setting】In the case of power failure occurred, all the settings include time will be preserved, the light will resume working after reconnection. And when the setting went wrong or confusing, please exit the DIY model and simultaneously press up & down keys for a few seconds until ‘SOP’ displayed, then unplug the power, and plug again at least 3 seconds later, all the previous settings will be cleared and restored to factory status.
【1-Year Replacement & 30 Days Money-back Warranty】Warrants our LED aquarium lights to be free of manufacturing defects. It’s normal if the light board may get hot after working for an extended period, just turn off the power and leave it for a while before touch. The DIY setting might be a bit complicated, please read the user manual carefully before kick-off, if you still encounter problems, please feel free to email us we will make it right for you.